If you need to measure the level of a liquid easily and reliably, most people will do this using hydrostatic pressure measurement, e.g. with a submersible pressure transmitter or a so called level probe. The characteristic submersed application implicates a maximum exposure to the encompassing, mainly water-based medium, respectively to ?moisture?.
Exposure isn’t only limited by the wetted elements of the pressure sensor housing, but also to the complete immersed length of the cable. Furthermore, outside the directly immersed level probe parts, the cable, and specifically the cable end, tend to be exposed to moisture because of splash water, rain and condensation. This is true not merely during operation, but even more during installation and commissioning, or when maintenance or retrofitting is necessary. Irrespective of the prospective application, whether in water and wastewater treatment or in tank monitoring, moisture ingress in to the cable ends of the submersible pressure transmitter can occur early and irreversibly with insufficient protection measures, and, in almost all cases, result in premature failure of the instrument.
The ingress of moisture into the cable outlet and from there on downwards into the electronics of the particular level probe should be actively eliminated by preventive actions by an individual. To gauge the level with highest accuracy, the varying ambient pressure above the liquid media, that is also ?resting? on the liquid, should be compensated against the hydrostatic pressure functioning on the pressure sensor (see article: hydrostatic level measurement).
Ventilation tube
Thus, it is logical that there surely is a constant threat of a moisture-related failure due to moisture ingress (both via the ventilation tube and through the specific cable itself) if there are no adequate protective measures. To pay the ambient pressure ? จำหน่ายเกจวัดแรงดัน ? on the media, a ventilation tube runs from the sensor element within the particular level probe, through the cable and from the level probe at the end of the cable. Because of capillary action within the ventialation tube used for ambient pressure compensation, moisture can also be transported from the surrounding ambience down to the sensor.
Thus not merely air, but also moisture penetrates in to the tube, hence the sensor inside the probe and the electronics around it really is irreparably damaged. This may result in measurement errors and, in the worst case, even to failure of the level probe. To prevent any premature failure, the ingress of moisture in to the ventilation tube must be completely prevented. Additional protection against moisture penetration through the ventilation tube is supplied by fitting an air-permeable, but water-impermeable filter element by the end of the vent tube.
bare wires
Not to be ignored can be the transport of the liquid through high-humidity loads along the only limitedly protected internals of the cable, e.g. across the wires, completely right down to the submersible pressure transmitter. As a respected manufacturer, WIKA uses appropriate structural design to prevent fluid transport, so far as possible, into the electronics of the submersible pressure transmitter. Because of molecular diffusion and capillary effects, a guaranteed one-hundred percent protection on the full duration of the submersible pressure transmitter, however, is never achievable.
It is therefore recommended that the cable is definitely terminated in a waterproof junction box with the appropriate IP protection (e.g. IP65) which is matched to the installation location. If this cable junction box is subjected to weather and varying temperature conditions, additionally it is recommended to pay focus on a controlled pressure equalisation to be able to prevent the formation of condensation or perspiration water and pumping effects. To address this technical requirement, being an accessory to a submersible pressure transmitter, you’ll be able to order a connection box having an integrated air-permeable, water-impermeable membrane.
Ultimately, moisture ingress can occur not only through the exposed end of the cable, but additionally through mechanical damage to the cable sheath or as a result of liquid diffusion due to improper chemical resistance of the cable material. In this article ?Selection criteria for the prevention of moisture-related failures of submersible pressure transmitters or level probes? this failure mode is described at length.
WIKA offers comprehensive solutions for the hydrostatic-pressure level measurement. For further assistance in selecting the submersible pressure transmitter the most suitable for your application, please use our contact page.
Please find more info on this topic on our information platform ?Hydrostatic level measurement?