Great ?dissipation loss? can be found in the info sheet for a pressure sensor or pressure transmitter. One needs this specification to become able to protect the pressure sensor from overheating.
If a pressure sensor is operated in a hot environment, it really is necessary to limit its electrical power. If one neglects this aspect, one possibly risks an overheating sufficient reason for this, in the worst case, a total failure of the instrument. Just how can the correct electrical connection be managed?
Determination of the correct electrical connection based on the dissipation loss
First, the utmost permissible electrical power for the pressure sensor must be known. Meticulous is given in the info sheet because the dissipation loss. Please note that the dissipation loss could be dependent upon the utmost expected operating temperature of the instrument and must be calculated where necessary.
If the allowable dissipation loss has been determined correctly, then your actual maximum electrical power for the pressure sensor occurring could be determined. The determination can be carried out expediently in two steps:
1. Determination of the voltage at the pressure transmitter utilizing the following formula:
UPressure transmitter = UVoltage source ? RLoad � Imax. Current supply
2. Calculation of the utmost electrical power for the pressure transmitter through the following equation:
PPressure transmitter = UPressure transmitter � Imax. Current supply
The maximum electrical power for the pressure transmitter (PPressure transmitter), that is now known, must be smaller than the permissible dissipation loss. If this is the case, both the power (UVoltage source) and the load (RLoad) were properly calculated and the electrical energy of the pressure sensor will undoubtedly be within the permissible range under all operating conditions. Consequently, the pressure transmitter won’t heat too strongly and will withstand the required operating temperatures.
Note
In Reflective need any advice, your contact will gladly help you.

Leave a Reply